Seacocks, Valves and Sea-Strainers
Groco bronze seacocks, valves and raw water strainers were installed on main engine, generator and air conditioner unit
All easy access
All DC main and sub-distribution panels were removed from the vessel, to include all components and all DC wiring circuits. A custom Blue Seas Systems was installed and all new wiring to make a complete installation under ABYC E-11, July 2008.
All AC main distribution panels were removed, to include all components and all AC wiring circuits. A custom Blue Seas Systems was installed and all new wiring to make a complete installation under ABYC E-11, July 2008.
AC Shore Power,2 30 AMP Shore Power inlets provide power to the main distribution panel within 10 feet of panels. Servicing both Shore Power inlets is a DEL Marine 100A fail safe galvanic isolator.
All 12VDC lighting and wiring were removed from the vessel. All new lighting fixtures, installed to include interior lighting, engine room lighting, cockpit lighting, navigational lighting, arch light and exterior cockpit lighting.
Grounding equipment aboard (Seacocks, metal chassis equipment, etc.). The grounding system was completely replaced with new cable fittings and related hardware. All grounding circuits were ohm-testing to ensure proper ties to ground at 1-ohm or less resistance.
Battery System: two main engine batteries group 27 AGM, two house batteries group 31AGM, bow thruster batteries group 27 AGM. All batteries cables fitting and terminals and enclosures were removed and replaced.
Dash Board has all new Togil switches, gauges and lighting.
Props and Shafts
Shafts were replaced with Aquamet stainless steel and dripless shaft seals from Lasdropb Gen2.
Propellers were removed, dynamically tested by PropScan and brought up to classification.
All interior upholstery, bulkheads, countertops and related hardware were removed from the vessel (staterooms, main salon, cockpit and head compartment). New (2008) custom upholstery was fabricated and installed to include Ultra-leather cushions in the main salon and new Corian countertops in the galley and head compartment.
Custom pillow top mattress in front cabin
Winshield was removed from boat including glass and gasket was removed from frames. Aluminum frames were bead blasted, primed and painted with Awlgrip Paint. Installed new tinted glass with all new hardware and custom center opening window for airflow.
Was removed from vessel, primed and painted with Awlgrip paint. Sliding mechanism was custom fabricated, new rollers were installed and door latch.
The original cabin-trunk hatches were cut out and removed. There were 2 new Bomar hatches with screens installed on the deck superstructure.
The original plastic hull ports were removed. The hull openings were modified and 6 new stainless steel opening portlights were installed.
A custom fabricated aluminum arch was installed between the bridge-deck and aft cockpit deck. The arch was prepared and painted with Awlgrip paint.